delfinoblu

, ATA, Flash drives, and SATA-II drives

Answer: A

Question: 10

How many front-end ports are required to provide failover between SPs for eight direct-attached
hosts on a CX4?

A. 16
B. 8
C. 4
D. 2

Answer: A

Question: 11

A customer has installed a new CX4 and is using ALUA SCSI communications with a Windows
2008 server and PowerPath.
The server is using two LUNs on the array and they are both owned by SP
A. Which statement
describes how IO is handled when a host has two paths to each SP, and there are no faults in this
environment?

A. IO will flow to the owning SP over the optimal paths.
B. IO will flow to each SP and load balance all paths.
C. IO will flow on only one path to each SP even if multiple paths are defined.
D. IO flows to the owning SP and then will use the CMI bus for additional IO.

Answer: A

Question: 12

What connectivity rules should be applied when configuring storage processor management ports
on a CX4?

A. Both ports must be on the same subnet.
B. Both ports must be connected via CAT 5 cabling.
C. Both ports must be connected via 10100 Ethernet.
D. Both ports must be directly connected to the host.

Answer: A

Question: 13

Refer to the exhibit.

Which port has a fixed IP and subnet mask?

A. A
B. B
C. C
D. D
E. E

Answer: A

Question: 14

Refer to the exhibit.

Which port is configured during array initialization?

A. A
B. B
C. C
D. D
E. E

Answer: B

Question: 15

A customer has requested onsite assistance because they are currently unable to communicate
with SP
A. You arrive onsite and connect to the GbE Service LAN. What IP address do you use to
connect to SPA?
A. 128.221.1.250
B. 192.168.1.250
C. 128.221.1.251
D. 192.168.1.251

Answer: A

Question: 16

What is the hard-coded Ethernet IP address of the SPB service port on a CX4?

A. 128.221.1.251
B. 128.122.2.251
C. 128.221.1.250
D. 128.122.2.250

Answer: A

Question: 17

What software is used to assign IP addresses when installing a new CLARiiON?

A. Unisphere Initialization Utility
B. Unisphere Server Utility
C. Unisphere Service Manager
D. Unisphere Client

Answer: A

Question: 18

What is used to identify the array when first starting the Unisphere Initialization Utility?

A. Serial number of the array
B. WWN seed of the SPE
C. IP address of the service port
D. Serial number of the management module

Answer: A

Question: 19

You are implementing Unisphere security on a CX4 CLARiiON with FLARE 30. The customer has
requested that all certificates be validated when naviseccli is used.
Global Knife Market 2016: Industry Analysis, Market Size, Share, Growth and Forecast 2019 Marketing Articles | July 11, 2016

Global Market Researc.